VIP-9880A
IP Square FlexHorn™, Square Hole Pattern, One-Way/Talkback Programmable, White
- Suitable for paging, background music & emergency alerts
- SIP enabled
- Recessed design for low profile appearances
- Powered by PoE (802.3af)
- Indoor only
- Software volume control
- High quality audio
- Surface mount
Overview
Valcom's VIP-9880A IP FlexHorn with Square Grille enables loudspeaker voice paging anywhere on an Ethernet network. The VIP-9880A consists of a high-efficiency Class-D Horn and a Network Interface, allowing standalone capability when used with a SIP-enabled telephone system or accessed from various Valcom managed VoIP products.
Specifications
SPEAKER ELEMENT
3.5-inch (8.9 cm)
Voice coil .75 dia (1.9cm), 45 Ohm
AUDIO OUTPUT
Rating: 108 dB @ 4ft (1.22m)
Signal/noise ratio: -70 dB
The -10dBm Line Level Out may be connected to up to 40 Valcom Self Amplified Speakers
FREQUENCY RESPONSE
400 Hz - 10 kHz
DISPERSION
120° Horizontal 90° Vertical
POWER REQUIREMENTS
Power over Ethernet (POE) 802.3af compatible
NETWORK
10/100 Mbps Ethernet
Manual or Dynamic Host Configuration Protocol (DHCP) IP address assignment.
Time and date synchronization using NTP
PROTOCOLS
IETF SIP (RFC3261)
IETF IGMP version 2 or 3 (RFC2236, RFC3376)
IETF RTP (RFC1889)
IETF RTP Payload for DTMF (RFC2833)
AUDIO CODECS
G.711 u-law, others
ACCESS METHODS
PBX, FXO Port w/VIP-811
POTS telephone set w/VIP-811
PBX, FXS Port w/VIP-821
SIP – enabled telephone system
Valcom M Cast Page Group
ENVIRONMENT
Indoor Installation only
Temperature: 0 to +40° C
Humidity: 0 to 85% non-precipitating
HOUSING & FINISH
The Horn is constructed with filled polypropylene
DIMENSIONS & WEIGHT
Dimensions:
10.75in H x 10.75in W x 4.00in D
(27.31cm x 27.31cm x 10.16cm)
Weight: 3.10lbs (1.41kg)
MOUNTING
The VIP-9880A is designed for flush mounting in a hollow surface or to a Valcom backbox
ACCESSORIES
VB-R17-D Recessed Backbox
Options
| Protocols | Part Number |
| Valcom IP | VIP-9880A |
| InformaCast® | VIP-9880A-IC |
| Syn-Apps® | VIP-9880A-SA |
Custom Colors available, add -CC after part number.
Resources
Installation Manuals
Technical Specifications
Simple Diagram
